PURSUIT 2670 Cuddy Console El manual del propietario descargar pdf (Pagina 36)

2670 Cuddy Console

COCKPIT SWITCH PANELS

Baitwell

This switch activates the baitwell light and circulating pump that supplies water to the baitwell. The pump

is protected by a circuit breaker in the panel and an automatically resetting breaker in the pump motor.

Washdown Pump

Located under the gunwale in the cockpit. This switch activates the raw water washdown pump. The pump

is the pressure demand type and is protected by a circuit breaker in the panel and an automatically resetting

breaker in the pump motor.

Note: Please refer to the Raw Water chapter for more information on the baitwell and washdown

systems.

Fishbox Pump Out Macerator Pump

The fishbox macerator switch panel is located in the rear of the cockpit near

the stern access door. It is a momentary switch that activates the overboard

macerator discharge system for the fishbox. The pump is protected by a

circuit breaker in the panel.

DC ACCESSORY BREAKER PANEL

Power is distributed to the 12-volt cabin accessories through individual

circuit breakers located in the DC panel in the center console storage

compartment. A main breaker, located on the TABS unit, protects the

system from an overload. Some 12-volt accessories are operated directly

by the circuit breaker in the panel while others are operated by switches fed by the panel breakers.

The following are descriptions of the accessories controlled by the cabin DC breaker panel:

Macerator

Supplies electrical current to the switch that controls the macerator overboard discharge pump for the holding

tank. This breaker should be in the “OFF” position except when pumping out the holding tank.

Refer to the Interior Equipment chapter for additional information on the operation of the overboard

macerator discharge system.

Electric Head

Supplies electrical current directly to the switch which controls the electric head.

Water Pressure

Supplies 12-volt electrical current directly to the fresh water pump pressure switch located on the pump. The

pressure switch automatically controls the water pump when the system is activated and properly primed.

MISCELLANEOUS ELECTRICAL COMPONENTS

Carbon Monoxide Detector

Twelve-volt electrical current is supplied to the carbon monoxide detector by a breaker located on the TABS.

This is a "push to reset" breaker that is normally on all the time unless tripped by an overload when activated

by the house battery switch. It should be checked, and the power indicator on the carbon monoxide detector

DC Breaker Panel

1 2 ... 31 32 33 34 35 36 37 38 39 40 41 ... 122 123

Sin comentarios

PURSUIT 2670 Cuddy Console El manual del propietario Pagina 36