PURSUIT 2670 Cuddy Console El manual del propietario descargar pdf (Pagina 55)

2670 Cuddy Console

Chapter 9:

EXTERIOR EQUIPMENT

9.1 Deck

Rails and Deck Hardware

The rail system and hardware fittings have been selected and installed to perform specific functions. Fenders

or mooring lines should be secured to the cleats and not to rails or stanchions. Mooring lines should be secured

to the cleats. Be sure a clear lead exists when running dock lines or anchor lines. A line inadvertently run

around a stanchion or over the rail could cause damage.

ALL FITTINGS MUST BE PERIODICALLY INSPECTED FOR LOOSE FIT OR WEAR AND

DAMAGE. ANY PROBLEMS SHOULD BE CORRECTED IMMEDIATELY.

PURSUIT BOATS ARE NOT EQUIPPED WITH HARDWARE DESIGNED FOR TOWING PUR-

POSES. THE MOORING CLEATS ARE NOT TO BE USED FOR TOWING ANOTHER VES-

SEL OR HAVING THIS BOAT TOWED.

Bow Pulpit and Roller

The bow pulpit is built into the hull and is equipped with a roller assembly

that allows the anchor to be operated and stored at the pulpit. The pulpit roller

is designed for a Delta

plow or a Danforth

style anchor. The anchor line

is stored in the rope locker and routed out the rope locker hatch through the

roller and connected to the anchor chain. A chain binder is provided on the

deck near the pulpit to secure the anchor. Always make sure the anchor

chain is secured by the chain binder before getting under way.

Anchor/Rope Locker

The anchor locker is in the bow of the boat and accessed through a hatch in

the deck. The locker is recessed for a Danforth

style anchor. The anchor

line is always stored in the locker. If an anchor is stored in the anchor locker,

it must be properly secured to prevent it from bouncing in the locker and

causing damage to the hull or anchor locker.

The anchor locker is drained by a thru-hull fitting in the hull side near the

bottom of the locker. It is very important to check the drain frequently to

make sure it is clean and free flowing.

THE ANCHOR MUST BE POSITIONED SO IT DOES NOT REST AGAINST THE HULL

SIDES AND BE PROPERLY SECURED AT ALL TIMES WHEN IT IS STORED IN THE AN-

CHOR LOCKER. A LOOSE ANCHOR IN THE ANCHOR LOCKER WILL BOUNCE AND

CAN DAMAGE THE BOAT. DAMAGE RESULTING FROM THE ANCHOR BOUNCING IN

THE ANCHOR LOCKER IS NOT COVERED BY THE PURSUIT WARRANTY.

Bow Pulpit, Roller and

Anchor/Rope Locker

1 2 ... 50 51 52 53 54 55 56 57 58 59 60 ... 122 123

Sin comentarios

PURSUIT 2670 Cuddy Console El manual del propietario Pagina 55