PURSUIT 2670 Cuddy Console El manual del propietario Pagina 35

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 123
  • Tabla de contenidos
  • SOLUCIÓN DE PROBLEMAS
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 34
2670 Cuddy Console
35
Horn
Activates the boat horn.
Bilge Pump
Activates the manual stern bilge pump which is installed in the rear center of the bilge. The pump moves
water out through the thru-hull fitting in the hull. To start the pump, put the switch in the “On”
position.
Note: The bilge is equipped with two bilge pumps. One pump is fully automatic and the other pump
is activated by a switch. The automatic pump will start automatically when there is sufficient
water in the bilge to activate the float switch. The float switch is protected by a circuit breaker
located on the TABS unit and is always supplied current when the batteries are connected. The
manual pump is activated by the bilge pump switch in the helm switch panel.
Parallel
The battery parallel switch is a momentary switch that will connect all three batteries in parallel for extra
battery power while starting the engines. A red LED light on the front of the TABS unit indicates that the
parallel switch is activated.
Nav/Anchor Lights
The switch is a three-position switch. The middle position is “OFF.” Moving the switch in one direction
will activate the navigation lights. Moving the switch in the opposite direction activates the anchor light.
Cockpit Lights
Activates the lights that illuminate the cockpit area.
Spreader Lights
Activates the flood lights located on the optional T-top. These lights provide additional lighting for the rear
of the cockpit.
Trim Tab Switches
Located in the helm switch panel. These switches control the trim tab planes located on the transom of the
boat. They are protected by the tabs breaker located in the helm 12-volt breaker panel. Please refer to the
Helm Control Systems chapter for detailed information on the operation of the trim tab controls.
Accessory Switch
This switch is supplied to protect additional equipment that may have been installed by Pursuit or your Pursuit
dealer. If no accessories are activated by this switch it remains wired in the panel in reserve.
12-Volt Receptacle
Provides electrical current for portable 12-volt equipment.
Windlass
Located in the helm. This switch controls the optional windlass which is mounted to the deck directly above
the rope locker. It is protected by a circuit breaker, of the type and rating recommended by the windlass
manufacturer, that is located on the TABS unit.
Vista de pagina 34
1 2 ... 30 31 32 33 34 35 36 37 38 39 40 ... 122 123

Comentarios a estos manuales

Sin comentarios