PURSUIT 2670 Cuddy Console El manual del propietario Pagina 45

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 123
  • Tabla de contenidos
  • SOLUCIÓN DE PROBLEMAS
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 44
2670 Cuddy Console
45
Chapter 6:
RAW WATER SYSTEM
6.1 General
In the raw or sea water systems, all water pumps are supplied by hoses connected to ball valves and thru-hull
fittings located in the bilge compartment. Always make sure the ball valves are open before attempting to
operate any component of the raw water system. 12-volt pumps supply sea water to most of the various
accessories.
Priming the System
Make sure the ball valves are open. Open the hose connector for the raw water washdown and activate the
pressure pump by turning the washdown pump switch to the “ON” position. Run the pump until all of the
air is purged from the system and then turn the switch off. Turn the livewell switch to the “ON” position.
Run the pump until all of the air is purged from the system and then turn the switch to the “OFF” position.
Closing the thru-hull ball valves before the boat is hauled from the water will help to eliminate air locks in
raw water systems.
It may be necessary to reprime the raw water system if the system is not used for an extended period and at
the time of launching.
6.2 High Pressure Washdown
A high pressure pump, controlled by a pressure sensor, supplies the raw water hose connector located in the
cockpit. The pump is activated by the washdown switch located in the rear of the cockpit. This switch should
be turned to the “ON” position just before using the washdown and be turned to the “OFF” position when the
washdown is not in use.
When activated, the pressure switch will automatically control the pump. As the pressure builds in the
washdown hose, the pump will shut off. When the washdown hose is in use and the pressure drops, the pump
will turn on.
The raw water washdown system is equipped with a sea strainer on the intake side of the pump located in the
bilge behind the stern access hatch. This should be checked frequently and cleaned as necessary.
The Washdown Pump Connector
The washdown pump hose connector is located in the cockpit and uses a standard
garden hose connection.
Washdown Hose
Connector
Vista de pagina 44
1 2 ... 40 41 42 43 44 45 46 47 48 49 50 ... 122 123

Comentarios a estos manuales

Sin comentarios