PURSUIT OS 255 El manual del propietario descargar pdf (Pagina 53)

Exterior Equipment

7-5

Section 7

OS 255

are accessed by using the manual valve

screw on the engine tilt cylinder and tilting

the engines down manually. Open the seat

in the normal fashion. Please refer to the

engine owner’s manual for instructions on

lowering the engines manually. Never use

the manual tilt valve screw when the boat is

in the water. Seawater can enter the power

tilt system and cause damage to the unit.

Hard Top

The hard top consists of a laminated fiber-

glass top mounted to a welded aluminum

frame bolted to the deck. It is designed to

accommodate radio antennas, radar anten-

nas and navigation lights. It could also be

equipped with optional outriggers and/or rod

holders.

The hard top is not designed to support the

additional weight of items like an instrument

locker or a life raft. Radar and electronics

antennas must be mounted to the top

between the front and rear legs. Do not

mount any antennas or equipment to the

brow area. The hard top frame is not

designed to support the weight of accesso-

ries in this area and could be damaged. The

starboard rear leg is the wire chase for lights

and antennas mounted to the top.

The warranty for the hard top will be void if

the top is modified in any way or heavy

accessories like life rafts or electronics lock-

ers are mounted to the top. Additionally, if

items like radar antennas, spotlights and

other accessories are mounted in the wrong

location, the warranty can be voided. If you

intend to add equipment or make modifica-

tions to the hard top, you should contact

Pursuit Customer Relations to make sure

the equipment you would like to add or the

intended modification will not void the war-

ranty on the top.

Hard Top Canvas

Because the aluminum frames vary slightly,

the side curtains, front clear connector and

drop curtain are custom made to each boat

at the factory. Slide the front clear connector

into the slide track at the front of the top and

snap it to the top of the windshield frame

beginning with the center snaps. The clear

connector will have to be stretched just

enough to pull out the wrinkles to reach the

snaps on the windshield.

Once the clear connector is installed, slide

the side curtains into the slide tracks on the

sides of the top and to the zippers on the

front of the connector. Snap the curtains to

the windshield and the deck beginning with

the forward snaps on the windshield. The

side curtains will have to be stretched

slightly to pull out the wrinkles and reach the

snaps.

If you have an optional drop curtain, slide it

into the slide track on the back of the hard

top and attach it to the rear of the side cur-

tains. Snap the drop curtain to the deck and

cockpit.

Cold weather can make the clear vinyl mate-

rial on the curtains stiff and difficult to stretch

to the snaps. This can be particularly difficult

with new canvas that has been stored off the

boat. Laying the curtains in the sun for 30

minutes during the heat of the day will make

installing them much easier in cold weather.

There is a hole drilled in one of the leg bases

to prevent water from being trapped within

the leg and provide a wire chase for acces-

sories. A small hole drilled in the tubing at

the base of the other legs, which are not

drilled for a wire chase, allows water to

drain. Clean the hardtop leg drain holes.

This is especially important just before win-

ter lay-up.

1 2 ... 48 49 50 51 52 53 54 55 56 57 58 ... 117 118

Comentarios a estos manuales

Sin comentarios