PURSUIT 2870 OFFSHORE El manual del propietario descargar pdf (Pagina 53)

2870 OFFSHORE

Chapter 6:

RAW WATER SYSTEM

6.1 General

In the raw or sea water systems, all water pumps are supplied by hoses connected to ball valves and

thru hull fittings located in the bilge compartment. Always make sure the ball valves are open before

attempting to operate any component of the raw water system. 12-volt pumps supply sea water to

most of the various accessories.

Priming the System

Make sure the ball valves are open. Open the hose connector for the raw water washdown and

activate the pressure pump by turning the washdown pump switch to the “ON” position. Run the

pump until all of the air is purged from the system and then turn the switch “OFF.” Turn the livewell

switch to the “ON” position. Run the pump until all of the air is purged from the system and then

turn the switch to the “OFF” position. Closing the thru hull ball valves before the boat is hauled

from the water will help to eliminate air locks in raw water systems.

Note: It may be necessary to reprime the raw water system if the system is not used for an

extended period and at the time of launching.

6-1

Raw Water System

1 2 ... 48 49 50 51 52 53 54 55 56 57 58 ... 139 140

Sin comentarios

PURSUIT 2870 OFFSHORE El manual del propietario Pagina 53